The purpose of a drip edge is to help redirect water from the fascia. Extends the longevity of your roof and improves its overall effectiveness. A drip edge is an angled piece of flashing that is installed over top of a fascia board.Assists gutters to direct water away from your house and foundation. Eave Flashing / Drip Edge Flashing Eave and Drip Flashings are used on the overhang, at the side or ends, and at the edge of the roof to protect the facade from a wide range of weather conditions.Prevents movement between fascia and deck boards.Helps protect the bottom of the roof line during ice dams that can occur during the winter months.Seals any gaps at the bottom of the roof - where there is often a gap between the decking and the fascia - which could allow small animals to enter the attic.Protects the edge of the decking due to water penetration during driving rains.Directs water away from the fascia and prevents water from rotting the fascia over time.It is non-corrosive and non-staining so that your roof looks good but is structurally stable. Drip edge overhangs the sides of the roof and has a small metal flange that is bent away from the fascia. It’s important to note that gutter apron and rake metal are often. The outward projecting lower edge in this picture is what is referred to as a drip edge. Drip edge is a metal flashing that is installed at the edges of the roof to help control the flow of water away from the fascia and to protect the underlying roofing components. Drip edge can be found on many metal flashings and components that are installed on your roof system, including: Gutter apron.
0 kommentar(er)
